flo CRS Patient Counseling Information

How to use and clean the FLO CRS Kit: 1. First time use. Thoroughly wash the bottle, tube and cap with warm soapy water. Rinse all components with clean tap water and dry using a clean paper towel.
2. Fill the bottle to the FILL LINE using lukewarm pre-boiled water.
NOTE: Water must be boiled for at least 1 minute before cooling until lukewarm. If more convenient, boiled water may be stored in a clean container in the refrigerator for up to 48 hours. You can re-heat the water in the FLO wash bottle using a microwave oven in 5 second bursts until it is lukewarm.
3. Cut or tear open one sachet of FLO CRS powder. Using the guidelines, fold out the sachet into a funnel shape and pour the entire contents into the FLO bottle.
4. Screw the cap and tube firmly onto the bottle and gently shake until all the powder has dissolved.
Your mixture is now ready for use.
5. Standing over a basin, bend forward and tilt your head down so that your chin almost touches your chest. Insert the tip of the cap gently into one nostril. Whilst breathing through your mouth, steadily and gently squeeze the bottle until the solution drains from the opposite nostril or from the mouth. Try not to swallow the solution. No harmful effects will occur if you do this. Whenever the bottle needs to refill with air, remove it from your nose before releasing your hand pressure. This helps to prevent "suck back" and contamination of the remaining solution. Repeat these steps until half the solution has been used, then repeat the procedure on the opposite nostril.
6. Gently blow your nose to clear any remaining fluid or mucus. Note: If you have recently had nasal or sinus surgery, do not blow your nose before checking with your surgeon.
7. Discard any solution remaining in the bottle. Always make a fresh solution for each treatment.
8. Cleaning after use: Wash all components with warm soapy water and rinse well. Dry with a clean paper towel. Firmly wipe all components using either a large alcohol swab or a clean paper towel which has been well moistened with isopropyl alcohol (available from pharmacies).
Be sure to wipe down the thread on the bottle neck and inside of the cap. Allow about 5 minutes for the alcohol to dry. This helps to disinfect all components and remove any moisture. Reassemble the FLO bottle and store in the refrigerator until next needed. BEFORE NEXT USE rinse the bottle with previously boiled water to remove any residue from the isopropyl alcohol.